147
edits
Changes
m
→Rigging
# Mount the glide computer using the RAM x-grip mount in the centre of the instrument panel
# Adjust the positioning by slightly loosen the two screw handles, make sure NO INSTRUMENT IS COVERED BY THE PHONE, then tighten the two screws again
# Plug in the usb power cable. You may need an adaptor, since the cable has an old micro USB connector.
=== Wing tape ===
# Check ballast requirements and remember the conversion between ballast weight and equivalent pilot weight (x2.5)
# Ballast weight weights go in the nose# Remove the nut (don’t loseit!)
# To add a ballast weight you will need to slightly close the canopy
# Replace the nut and secure the ballast weights